Hey everyone,

Decided to make a post here on the forum about the 3D printed fuel cap holders that I came up with last fall. I came up with these as I had seen similar concepts before but wasn't happy with the fit or finish of those, personally. These are designed to snap into the stamped frame of the fuel door and clear the gas cap when closed. With this installed you'll have a secure place to set the cap while you're pumping gas so you don't accidentally lose it if you don't have the factory lanyard attached. I don't have any meat & feet pictures to go along with this listing so I hope you won't think I'm a bot.    I'll sweeten the deal by offering a 5% discount on your order of one if you use code SAABCLUB at checkout.

You can find them at https://chasedtoast.bigcartel.com/produ … lder-wagon and thank you for your consideration!

Here's some installed photos and a quick YouTube video to show how it's installed and it's function.

https://www.youtube.com/watch?v=HMI7J_6 … erformance





     

Last edited by ChasedToast (2021-05-14 12:40:07)